SKU: N/AThis site contains affiliate links for which we may be compensated
Consumer Electronics / Vehicle Electronics & GPS / Car Audio / Car Amplifiers
Subwoofers Amplified Car Subwoofer - Low Profile, 10 Inch Subwoofer, Remote Subwoofer Control SLIM10 Break Your Subwoofer In. Much like the engine of a new automobile, a new subwoofer must go through a short but important process of “break-in” before it is run under harsh conditions. The “break-in” process will ensure the subwoofer is able to perform as it has been designed to. This process involves subjecting the subwoofer to no more than low-to-medium volume levels for a number of hours in the enclosure. 3-4 hours is generally sufficient for the subwoofer’s suspension to loosen enough to prevent the voice coil(s) from overheating and causing failure. The break-in period is also effective in extending subwoofer life. Over-driving the woofer before it has been properly broken-in will usually result in premature failure and poor performance. • One 10" Woofer with SINGLE 2.6 ohm Voice Coil • 1000 Watts MAX 500 Watts RMS Power Handling • RCA & Speaker Level Inputs, High Level Inputs • Thermal, Short and Overload Protection Circuits, Power & Protection LEDs • Phase Control, Low Pass Crossover, Variable Bass Boost, Input Gain Control Features IPX5 Rating The IPX5 Rating means that the equipment will be protected against low pressure water stream from any angle. High & Low Level Inputs High-level inputs accept speaker output signals and low-level inputs accept pre-amp output signals to allow for the addition of amps and processors to standard factory or aftermarket source units. Mosfet Power Supply Metal Oxide Semiconductor Field-Effect Transistors quickly switch from full to non-conduction for high efficiency output. Class A/B Our Class-A/B amplifiers feature specific linear circuitry that increases sound quality and power output while reducing distortion and improving efficiency. Variable Low Pass Filter Variable low-pass filter gives you control over the frequencies that pass through to the subwoofer. Variable Bass Boost Variable Bass Boost allows you to adjust the low bass within the boost range to just the way you like it. Phase Control This function on the amplifier comes in handy for custom installations where you might need to have your speakers or subwoofers mounted the non-traditional way with the magnet facing out. Let us explain. You can set the Phase anywhere from 0 degrees to 180 degrees. What this does is that it reverses the polarity (Positive/Negative) on your subwoofer terminals which in turn reverse the direction of the low frequency BOOM that you are used to hearing. Variable Gain Control The Variable Input Control allows the amplifier input to match the output signal from the head unit to achieve optimum performance when adjusted properly.
Returns Accepted for this item if it's within 30 Days